logo
Found 24 products for "

316l multiple effect evaporation system

"
質 消費のNaclの蒸気化の結晶化のための救うチタニウムMvrシステム 工場

消費のNaclの蒸気化の結晶化のための救うチタニウムMvrシステム

Consumption Saving Ti MVR System For NaCl Evaporative Crystallization The Titanium (Ti) MVR evaporation & crystallization system is purpose-built for table salt and industrial salt. By mechanically recompressing and reusing latent heat, it cuts specific energy use and fresh steam demand while ...

質 ペーパー パルプの廃水の蒸化器で使用される高く有効な枕版 工場

ペーパー パルプの廃水の蒸化器で使用される高く有効な枕版

Critical equipment for the chemical pulp mill Black liquor evaporation is an essential part of the chemical recovery process as it significantly concentrates the dry solid matter in black liquor so that the liquor can be effectively combusted in recovery boiler. The water removed from the liquor can ...

質 オーダーメイド エムボスされた枕シート 熱交換器 省エネ メカニカル蒸気再圧 MVR蒸発器 工場

オーダーメイド エムボスされた枕シート 熱交換器 省エネ メカニカル蒸気再圧 MVR蒸発器

Industrial mechanical vapour recompression MVR A heat pump uses energy to transfer heat from a lower temperature source to a higher temperature demand using additional energy. For industrial heat pumps, the heat source is process waste heat. Mechanical vapour recompression (MVR) is an open heat pump ...

質 製紙の企業の黒液の処置のための中国の質の窪みの版の熱交換器 工場

製紙の企業の黒液の処置のための中国の質の窪みの版の熱交換器

Multiple-effect evaporator and concentrator Evaporation plants are well-proven in installations around the world. There are a variety of configurations and models available – from pre-evaporators to multiple-effect evaporation trains – to accommodate even the most challenging pulp mill or effluent ...

質 溶接される窪みを作られる熱交換器をめっきしなさい 工場

溶接される窪みを作られる熱交換器をめっきしなさい

Welded Pillow plate heat exchanger for falling film MVR evaporator system MVR Technology MVR technology is to compress the secondary steam of the evaporator by mechanical method, increase its pressure and temperature, increase its enthalpy, and then send it back to the heating chamber of the ...

質 パルプ黒い水集中の熱交換器の塗布のための枕版の製造者 工場

パルプ黒い水集中の熱交換器の塗布のための枕版の製造者

MVR Technology MVR technology is to compress the secondary steam of the evaporator by mechanical method, increase its pressure and temperature, increase its enthalpy, and then send it back to the heating chamber of the evaporator to be used as heating steam, so as to keep the feed liquid in boiling ...

Previous
Page 3 の 3
Next